*Available in standard white, as well as tan, brown or gray (on exposed areas only).
Mid-Wall Weep Screed
Mid-Wall Weep Screed (Patent Pending) performs as an unpunched weep screed allowing excess moisture to escape the back of a stucco membrane. This screed also performs as an expansion (control) joint with twin grounds. It is installed where a framed stucco surface meets a masonry (concrete block) stucco surface. This condition is common between floors on 2-story homes and at the base of a gable receiving stucco.
The unpunched flange above must be installed extending at least one inch below the framing/ concrete joint. The weather barrier and lath should be installed over the solid upper flange to direct water to the foundation weep screed. The profile is manufactured with a 3½” nailing flange as required by code.
Mid-Wall Weep Screed
PRODUCT NO. | GROUND A | GROUND B | BOX COUNT |
|---|---|---|---|
MID-WALL WEEP SCREED AMMWS-780-500 | 7⁄8" | 1⁄2" | 15 |
MID-WALL WEEP SCREED AMMWS-780-580* | 7⁄8" | 5⁄8" | 15 |
Standard Length: 10 Feet